• Highly resistant to wear & tear.
• Fluoride release prevents decay and strengthens enamel.
• Easy-to-use syringe delivery system.
• Prevents food & microbes entrapment into pits & fissures.
• Forms a strong bond with enamel for long-lasting protection.
• Low shrinkage for a tight seal, optimal retention.
• Radiopaque for easy identification during check-ups.

Waldent FissureSeal is a light-curing, fluoride-releasing dental sealant designed to provide exceptional protection for occlusal surfaces. Its optimal flow characteristics enable deeper penetration, resulting in a tighter seal that enhances mechanical retention. The unique resin system of FissureSeal reduces shrinkage, ensuring a tighter seal that offers superior protection against decay and bacteria. FissureSeal's inorganic filler component is specially designed to maximize fluoride release, offering long-term benefits for patients

Indications

• Sealing/filling pits and fissures as well as small cavities.
• Restoring damaged enamel surfaces.
• Anchoring orthodontic appliances and covering caries predilection sites during orthodontic treatments.
• Sealing deciduous teeth.
• Sealing composite or cement fillings.
• Repairing small defects in composite and amalgam fillings.

Contraindications

• Do not apply over carious lesions.
• Do not apply to unetched surfaces.
• Do not use FissureSeal on patients with known sensitivity to methacrylate or other resins.

Composition

• Silanated Barium Glass Powder (Inorganic fillers)
• Urethane Dimethacrylate
• Triethylene Glycol Dimethacrylate
• Amorphous Fumed Silica
• Curing Agents, and Stabilizer.

Storage

• Store in a cool and dry place
• Store at room temperature of 5-30°C
• Do not freeze
• Store away from direct sunlight

• 1 x 2gm syringe
• 4 x Black Tip (20 gauge)

• Use a non-fluoridated and oil-free prophylaxis paste to clean the occlusal surface of teeth with pit and fissure sites
• Remove minimal caries from pits and fissures using small round burs in a
  slow-speed handpiece, being careful not to extend beyond the affected area.
• Rinse thoroughly with water and isolate the tooth.
• Ensure the surface is dry by using clean, dry, oil-free air before etching
• Apply 37% phosphoric acid, like Waldent BestEtch, on the occlusal surface for 10-15 seconds, not exceeding 30 seconds.
• Thoroughly rinse with water
• Completely dry the tooth surface with oil-free air for 15 seconds.
• Place Waldent FissureSeal on the prepared tooth surface.
• Use the Waldent Eco Plus LED Light Curing Unit or any other LED curing light to cure the sealant for 20 seconds.
• Additional increments may be applied if necessary with continued isolation and dry operating site.

Warranty is not applicable for this product

Question) Is this radiopaque?

Answer: Yes, Waldent FissureSeal Pit & Fissure Sealant LC is radiopaque.